* chore: remove ipfs-utils dep
We only use it for the env detection, so use [wherearewe](https://www.npmjs.com/package/wherearewe)
instead which is that, but pulled out into a tiny module.
The `TextDecoder` class is global everywhere we support so we don't
need to pull it in from `ipfs-utils` and it's been removed from v8
anyway.
* chore: update ipfs-http-client
BREAKING CHANGES:
top level types were updated, multiaddr@9.0.0 is used, dialer and keychain internal property names changed and connectionManager minPeers is not supported anymore
* feat: add uPnP nat manager
Adds a really basic nat manager that attempts to use UPnP to punch
a hole through your router for any IPV4 tcp addresses you have
configured.
Adds any configured addresses to the node's observed addresses list
and adds observed addresses to `libp2p.multiaddrs` so we exchange
them with peers when performing `identify` and people can dial you.
Adds configuration options under `config.nat`
Hole punching is async to not affect start up time.
Co-authored-by: Vasco Santos <vasco.santos@moxy.studio>
BREAKING CHANGE: pubsub signing policy properties were changed according to libp2p-interfaces changes to a single property. The emitSelf option default value was also modified to match the routers value
* chore: examples not using secio
* chore(docs): remove unused dep
* chore(docs): remove reference of secio in setup
* chore(docs): replace circuit secio reference with noise
Co-authored-by: Jacob Heun <jacobheun@gmail.com>
* fix: not dial all known peers on startup
* feat: connection manager should proactively connect to peers from peerStore
* chore: increase bundle size
* fix: do connMgr proactive dial on an interval
* chore: address review
* chore: use retimer reschedule
* chore: address review
* fix: use minConnections in default config
* chore: minPeers to minConnections everywhere
* docs: getting started
* docs: review getting started (#520)
* doc: initial review of getting started
Co-Authored-By: Vasco Santos <vasco.santos@moxy.studio>
* chore: move multiplexing to basic setup
* chore: add read more cta
* chore: apply suggestions from code review
Co-Authored-By: Jacob Heun <jacobheun@gmail.com>
* chore: just configure multiplexer
* chore: apply suggestions from code review
Co-Authored-By: Jacob Heun <jacobheun@gmail.com>
* chore: just use websockets and changed dht module introduction
* chore: add reference for events in the API doc
* docs: simplify getting started guide and clean up language
* chore: apply suggestions from code review
Co-Authored-By: Alan Shaw <alan.shaw@protocol.ai>
* docs(fix): address review comments
Co-authored-by: Jacob Heun <jacobheun@gmail.com>
Co-authored-by: Alan Shaw <alan.shaw@protocol.ai>
